If you haven't worked around an airbag before, don't. They are very sensitive and can explode, causing quite a bit of damage and possibly killing YOU. To work on the keyswitch you have to FIRST remove the airbag assembly and the steering wheel. Then you can get to the retaining assembly that holds the lock into place. It's a little different for each vehicle type, but basically it's simple once the airbag and steering wheel are removed. If you insist on removing the airbag you'll need a wheel puller to remove the steering wheel. It's not possible to adequately express the danger involved in messing with airbags if you aren't familiar with them. Just a tiny static discharge will cause it to explode.
0.60
passenger side fender
how do you get ignition switch out of steering column in 2000 catera?
You can remove the 2000 Chevrolet Astro Van the ignition switch cylinder by removing the retaining ring. The retaining ring will need to be turned to the left. The ignition switch cylinder will slide out.
very carefully!
In a 2000 Oldsmobile Alero : Both the 2.4 litre four cylinder engine and the 3.4 litre V6 engine have a timing CHAIN
A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.
You need to remove the engine top cover to access the ignition parts.
To remove the ignition cylinder on a 2000 Lexus RX300, first remove the vanity engine cover by unscrewing it. Disconnect the wiring connector by pushing the clip that holds it in place. Finally, remove the bolts that hold the ignition cylinder.
Unless you want to lose your $1200 air bag, take it to an authorized mechanic.
Remove the retaining ring from the top of your 2000 Mercedes-Benz ignition lock cylinder. Slide the ignition lock cylinder out and remove the wiring harness.
I am assuming you mean the engine: 2.4L 4 cylinder engine: 4.25qts 3.4L 6 cylinder engine: 4.5qts