Chevy Silverado

How do you change the ignition lock on an 86 Chevy Silverado?

151617

Top Answer
User Avatar
Wiki User
Answered
2009-11-04 01:20:30
2009-11-04 01:20:30
Answer

put your ignition key in the lock turnit to accesory, there will be a small pinhole you will have to stick a pin of some sort in there and then it should just pop right out.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Begin by removing the retaining ring at the top of your 1996 Chevrolet Silverado ignition lock cylinder. Slide the ignition lock out and remove the wiring harness. Reverse the process to install your new ignition lock cylinder.

The lock/tumbler has to be in time with the ignition switch. I suspect it is not.

How do you un lock a raido on a 2003 chevy silverado

Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.

The first two are how I unlock my truck: - Stock Keyless Entry - Door/Ignition Key - Aftermarket Keyless - Slim Jim after you lock yourself out

Where is the door lock module for 98 chevy Remote

Is it the switch, or the lock that you want to replace?

A locksmith may be able to remove the broke key and make a new one. Or just replace the ignition.

per my recollection, you must turn the ignition to the on position for 5 min, switch it off /back on for another 5 min. Off then back on for another 5 minutes. Then it should be programmed.

How do I replace an Ignition in a 1970 Maverick

You will need to attach the wiring harness to the end of your 1984 Chevrolet Blazer ignition lock cylinder. Slide the cylinder into the cylinder slot. Secure the ignition lock cylinder with the retaining ring.

When the ignition key won't turn in a car or truck, it could be that the pins in the lock cylinder came out and locked the lock. Also, if the key is old, it could be worn down too much. One other thing a person should try is rocking the wheel while turning the key. It also could be that the ignition switch needs to be replaced.

To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.

You would have to drill out the center of the lock or have a locksmith pick the lock.

To change the ignition key lock you have to: 1. Pull the steering wheel off. 2. Remove the lock plate. 3. Remove the turn signal switch. 4. Remove the set of contacts. 5. Remove the retainer bolt. The lock will then pull out of the housing.

To remove the igniton lock, remove the steering wheel and turn signal switch housing. From there you will be able to see the lock which holds the ignition lock into place. slide a screwdriver into the slot and apply pressure. The igntion lock can then be pulled out.

The ignition switch should be separate from the ignition key/lock assembly, so I'll say no.

The wheel should lock when you take the key out of the ignition. If it doesn't, there's something wrong.

I broke my key in the ignition and cant get it out. My only option I can see, is to replace to tumbler. How do I remove it?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.