A locksmith may be able to remove the broke key and make a new one. Or just replace the ignition.
too much weight from too many keys cause the cylinder to wear out. try attaching key to breakaway keychain to reduce weight.
With the key stuck in the accessory position the steering wheel is locked and the gearshift is locked in the park position. Perhaps you should consider having a locksmith change the key cylinder where it is, or else have it towed to the garage.
I'd call a locksmith. The ignition wil probably have to be drilled and replaced.
The 327 cubic inch Chevrolet's distributor had points and condenser and not an ignition module. If you have an ignition module then you have a HEI distributor that was changed out.
under neth the coil packs middle back of engine 3 bolts you will need a 10 milimiter 12 milimeter and 13 i did mine 4 TIMES !!!!
can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode
i need the bracket that the ignition cylinder slides into.... the piece that mounts to the stering column
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
== ==
123456
How do i change the ignition switch in a 1988 Chevy camaro
It is straight underneath the starter
You will need to remove the retaining ring from the top of your 1975 Chevrolet pickup truck ignition cylinder. Slide the ignition cylinder out and remove the wiring harness. Reverse the process to install the new ignition cylinder.
You will need to attach the wiring harness to the end of your 1984 Chevrolet Blazer ignition lock cylinder. Slide the cylinder into the cylinder slot. Secure the ignition lock cylinder with the retaining ring.
no
k8wdc
The drivers side is the odd side, #1 is in front.