Starters and Ignition Systems
Pontiac Bonneville
Ford F-150

How do you change the ignition switch on a 1989 Pontiac Bonneville?

909192

Top Answer
User Avatar
Wiki User
2015-07-15 19:51:38
2015-07-15 19:51:38

You have to remove the steering wheel, horn and turn signal assemblies. Make sure your wheels are straight before you remove the steering wheel. Remember the proper order of parts for re-assembly and get the GM steering wheel compressor tool as well as a good steering wheel puller. The switch requires the key in it to remove. There is a spring loaded catch at the rear of the cylinder that locks it into place. Once this is depressed, it will just pop out. Make sure the battery is dis-connected before beginning and if the compressor tool isn't available, get a buddy with a good set of shoulders to hold the wheel down while you place the main nut. A little tricky if you haven't done one before.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You can remove your 1997 Pontiac Bonneville ignition switch by removing the retaining ring at the top of the ignition switch. The ignition switch will slide out.

User Avatar

How do you replace the ignition swith opn a 1992 Pontiac Bonneville se

User Avatar

Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.

User Avatar

I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.

User Avatar

Answering "1999 Pontiac Bonneville fuel shut off switch?"

User Avatar

I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.

User Avatar

If its the kind with the special metal piece in the key there is no way to reset it you have to change the whole ignition switch

User Avatar

i would change the electrical part of your ignition switch- i would change the electrical part of your ignition switch-

User Avatar

howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy

User Avatar

You can change your 1995 Chevrolet ignition switch by removing the ring at the top of the ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.

User Avatar

No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.

User Avatar

How do i change the ignition switch in a 1988 Chevy camaro

User Avatar

How change ignition switch in Lexus ES 300

User Avatar

how to change manual ignition switch on a 93 Honda accord

User Avatar

The 1994 Pontiac Bonneville fog light switch can be found on the center console. The fog light switch will be?รฆbelow the climate control panel.

User Avatar

how to change a ignition switch on a nissan altima 2003

User Avatar

if engine will not turn over, check fuses first. then check battery, starter motor, starter motor solenoid and ignition switch

User Avatar

how do you change the ignition key switch on a 1994 nissian sentra se

User Avatar

Changed the ignition?? The key tumbler? The switch itself? The parts under the hood? IF the key, was the part in the column in good condition. Did the key assembly seat properly? If the switch itself, it is adjustable to a degree and may not be in the right place. Under the hood? Depends of what was changed.

User Avatar

Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.