0
How do you change the ignition switch on a 1991 Pontiac grand am tilt steering automatic trans?
Wiki User
∙ 14y ago
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Is there a way to change the ignition switch on a 1990 Pontiac Grand Prix 3.1 liter automatic transmission tilt steering without pulling the column?
YES
How do you change the ignition switch in a 1990 Pontiac Grand Prix without pulling the steering column?
the ign switch or the key & tumbler ???
How do you change ignition switch on 1998 Buick century Do you have to remove the steering wheel?
do I remove steering wheel to change out ignition
How do you replace steering column on 1986 Pontiac parisienne?
how to change steering column on 86 pontiac bonneville
Why would a 1991 Pontiac Firebird not start after you replaced the steering column?
Because when you change the ignition in a firebird you have to use the same key and key lock that was on the original column. If you don
How to change the ignition switch?
Lower the steering colunm. the ignition switch is located on the top of the steering column about 6 inches from the firewall.
How do you change the ignition cylinder on a 1991 Cadillac Eldorado?
Remove steering wheel and signal switch
How do you Change ignition for ford e350 diesel cube van?
Not sure what you mean by change the ignition on a diesel, diesel engines don't have spark plugs, spark plus wires, coil, etc.... If you are asking about the ignition switch, it is mounted on top of the steering column on most pre 2000, after that they are located in the steering column.
When I start my 1995 Pontiac Transport 3800 the heater fan and wipers do not work unless I turn the ignition key up.?
i would change the electrical part of your ignition switch- i would change the electrical part of your ignition switch-
How do you change ignition switch?
You will have to remove the steering wheel and everythin that surrounds the steering column in order to get the ignition switch out. I would suggest getting a good repair manual as this is not an easy process to describe without pictures and such.
How do you remove ignition switch cover on an Pontiac Aztek?
On my 2001 Aztek, I could pull the key out when driving. To change the ignition without removing the steering wheel, take the two screws out from underneath the covering behind the wheel. Not the screws on the steering wheel. The cover will lift up but won't come off. Take an Alleen wrench and feel for the hole on top of the ignition (it will be a tight squeeze), and push in. I should also say remove the black or gray cover on the ignition switch (where the key goes in). Once you find the hole and push down on it, the ignition switch will come out.
Do you have to take the steering wheel off to change a ignition lock tumbler on a 96 Chevy Tahoe?
yes
