Get 2 #168 bulbs then open the hatch. Look on the passenger side for the inset handle remove the screw and the plastic piece comes off. Then pry off the plastic cover. The bulb holders are up in two cutouts behind the license plate. Unplug the connector by squeezing and pulling it out. Then turn the bulb holder counter clockwise (I did it by pushing the connector piece up and it popped out). Replace the bulb, then the holder, then replug the wire. Test then re-assemble. P.S. Don't drop the connector when you try to re-install it is a pain to get out of the bottom of the hatch!!!!!!
Could you please narrow down what lightbulb?
how do u change the license plate light on a 2005 sienna
o2 censor
The engine warning light for emissions might come on in a Toyota Celica if the Oxygen Sensors are bad. It might also come on if the catalytic converter is not working properly or is plugged.
You have to pop the panels off inside of your hatch, right on the other side of the tail lights, you should be able to see the back of the tail light from there.
The 2001 Toyota Camry license plate light fuse can be found in the fuse box. The license plate fuse will be labeled as the tail light fuse.
if its like a "86" you just pull back on the light switch i
The fender must be removed so the light will slip out
http://store.ledmod.com/index.php?main_page=product_info&cPath=3_27&products_id=46 there's an install guide at the bottom, good luck!
open the trunk and take off the cover and just do it
Changing a rear license plate light on a 1991 Toyota Corolla will be very easy to do. You need to take the license plate off and then unscrew all the plastic screws holding the light cover in place. After the screws are out, remove the cover and unscrew the old bulb and replace it with a new one.
How do you change the tail light on a 2001 toyota sequoia