As a gm certified tech, i have replaced many of these intake gaskets. It takes about five hours as a professional and it involves dismantling the top of the motor. Not an easy task. As long as the motor is not noisy the motor should be fine once the coolant oil mixture has been drained. Should change the oil a few times to be sure all the coolant is out
Procedure to change 1988 Buick regal head gasket
The intake manifold, head, and exhaust manifold must be removed to gain access to the gasket.
Its located in the air intake
how to replace master cylinder on 1996 buick regal
right above the neck
how do you change the rear license plate light on a 1999 Buick Regal
On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.
how to replace windsheild washer pump 2003 buick regal
the only way oil will get in the coolent is a bad head gasket or a crack in the head.
Exhaust manifold gasket leaking
I have a 2000 Buick Regal GS how do I change my front sway bar
I need to know if I need a special to to change my serpentine belt on a 2001 Buick Regal
If you get the PCM, engine wiring harness, and intake manifold from the Regal also..
Buick Regal was created in 1973.
head gasket may need to be replaced
You have to get under the car and change it that way.
which fuze controls the air in a buick regal
P0410 2002 buick regal
You can't (not legally, anyway)
As soon as the 2003 Buick Regal change oil light comes on, it is important to do so immediately. Not changing your oil can damage the motor in your car.
where is the thermostat located on 95 buick regal
Buick regal doesn't have a timing belt. It has an accesory belt and is change between 50,000 to 60,000. In my case i replace the accesory belt when my car was 80,000 milles.
Take old lights out. Put new lights in. Done. You have just changed the interior lights on a 97 Buick Regal!
Hey Andre==You don[t say which side but just get everything out of the way, remove the screws and take the valve cover off.