Lower passenger side below air pump. Break the fuel supply lines but, do not remove. 2 bolts on either side of pump. loosen but, do not remove. wiggle the pump until it breaks free of block. rotate engine until cam is at it"s lowest position. This will reduce the pressure against the fuel pump rod. remove fuel lines then bolts. pull pump from engine. Scrape pad on engine to remove old gasket. Install new gasket and reverse steps from above
if the engine is stock it has 160 horsepower
front passanger side of block it is mechanical.
No, the first tubro-diesel pickup that Ford released (in the F series) was in 1995. you could get a turbo powered diesel from ford as early as 93. in 94 international began butting them on at the factory.
I need to change the fuse on the horn and hazzard lights on 1990 toyota pickup, what amp should I use?
it's underneath the rotor in the distributor. you have to take the distributor out to change it.
if it is a ford ranger,it may work because the masda got its body style form ford for that pickup
According to the AutoZone website : For a 1990 Ford F-350 , 7.3 liter Diesel V8 engine : With engine oil filter change : ( 9.8 U.S. quarts )
what's the pis of the 1990 v6 isuzu pickup fuel pump
Yes, you can change the engine of a Toyota used car from diesel to petrol or LPG Gas. Some D2 engines are used in late models already have diesel engines.
The lift pump is on the lower driver side of the engine block. The injection pump is on the upper driver front side of the block.
Open the tailgate. About 5" back from where the tailgate closes, there are two 10mm screws on the edge.
A 2003 Dodge diesel manual transmission will work in 1990 Dodge diesel manual and bolt to the 1990's transfer case with little fabrication.