time for an oil change
replacement of the transmission dipstick tub seal on a 1994 s10 blazer
To drain the oil on a 1991 Chevy S10 Blazer, located the oil pan drain plug. Use a wrench to remove the plug and the oil will flow into the receptacle you have provided.
Inside of oil pan.
4 and 1/2 Qts with filter change.
4 and 1/2 qts with filter change.
Yes you can.
how do you change the oil pump on a 1991 s10 pickup
In the oil pan
I have a 2001, and after a oil change and slight tune up i get about 20.5 hwy and 15-16 city.
The 4.3L engine holds 4.5 qts with filter change.
it is under the distributor.
OK there are two ways to change the oil pump on a 1995 Chevrolet s10 2.2L. Because A cross member is made to the frame right under the oil pan you will haft to either take the engine out or take out the motor mounts and jack the motor up for clearence to get to the oil pan its self.
The 1987 s10 Blazer uses 4.5 quarts of oil. Make sure to check the amount using the dipstick as the amount could vary due to all of the old oil not draining completely.
5W-30 in most climates.
Yes, there is no reason you should not be able to change the oil by yourself in a 1996 Chevrolet S10.
AnswerThe engine oil drain plug is located at the lowest point on the engine oil pan.
Next to the distributor
The oil capacity of a 1995 Chevy S10 V6 4.3L is 4.5 quarts when the oil filter is also changed. Oil levels should be checked with the dip stick to verify levels.
I have a 2000 Chevy Blazer LT and it ran great until I took it to a Valvoline for an oil change. I had over 160,000 miles on it and they put the wrong oil filter on it to cause my engine to seize. Jeff- Sioux Falls, SD