The O2 sensor is located on the exhaust, most Cherokee's have 2 exhaust banks, so there should be one on each side of the engine. Find a wrench to fit it and screw it out, there should be an electrical connection running to it so find where it connects and disconnect it. Reverse for installation.
I had that same exact problem with a 1995 Jeep Cherokee, and it was indeed a bad oxygen sensor. Relatively cheap repair too.
There is no such sensor, the oil change reminder only runs off of mileage on a 2004
There is no afs on a cherokee, they run on a map sensor.
Check the oxygen sensor. My 1995 Grand Cherokee stopped stalling while driving after it was replaced.
The heated oxygen sensor, or O2 sensor is located at the exhaust system before the catalytic converter. Removal & Installation # Raise the vehicle and support it with jackstands. # Disengage the O2 sensor wiring connector and remove it using tool YA 8875, or its equivalent. # Inspect the threads of the new O2 sensor. Apply an anti-seize compound only if there is none visible on the threads. Be careful not to contaminate the sensor tip with any foreign compounds. # Install the sensor using tool YA 8875, or its equivalent and engage the wiring connector.
How do you change oxygen sensor on a 2006 Chevy aveo?"
How do you change oxygen sensor in 1992 Toyota corolla? Is there a model engine 4A-FE without a oxygen sensor?
In the exhaust pipe, near the engine.
I had that same exact problem with a 1995 Jeep Cherokee, and it was indeed a bad oxygen sensor. Relatively cheap repair too.
Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
OEM stands for original equipment manufacturer. The Oxygen sensor senses amounts of oxygen in the exuast to adjust the fuel mixture acordingly.
# The sensor is located in the exhaust manifold or exhaust pipe and is accessible from under the vehicle # Since the oxygen sensor may be difficult to remove with the engine cold begin by operating the engine until it has warmed to atleast 120 degrees # Disconnect the electrical wire from the oxygen sensor and carefully unscrew the oxygen sensor from the exhaust pipe.Be adviced that excessive force may damage the threads inspect the oxygen sensor for damage unless you are replacing it
It is called an oxygen sensor socket.
# The sensor is located in the exhaust manifold or exhaust pipe and is accessible from under the vehicle # Since the oxygen sensor may be difficult to remove with the engine cold begin by operating the engine until it has warmed to atleast 120 degrees # Disconnect the electrical wire from the oxygen sensor and carefully unscrew the oxygen sensor from the exhaust pipe.Be adviced that excessive force may damage the threads inspect the oxygen sensor for damage unless you are replacing it
The 1981 Ford Crown Victoria does not have an Oxygen sensor.