Power Steering

How do you change the power steering pump on a 2000 Malibu?

345

Top Answer
User Avatar
Wiki User
Answered
2008-08-24 23:46:17
2008-08-24 23:46:17

Your best bet is to buy a Haynes Manual that is for your car. While you are at it you will need a power steering pulley puller and installer.

001
🙏
0
🤨
0
😮
0
😂
0

Related Questions


The power steering fluid is leaking because somewhere in the power steering system there is a leak. It is possible one of the seals on the steering rack has worn out. That would be a good place to start. It could also be coming from a leaky seal on the power steering pump or from one of the lines.

With a puller made for that. Most auto part stores have one that they loan out.

I have a 2000 Malibu and the fog light button is to the left of the steering wheel close to the cupholder.

How do you replace a power steering reservoir for a 2000 odlsmobile interigue?

Is there two power steering pump on a 2000 Lincoln LS

ball joints could be bad Did you make sure you got all the air out of the power steering system?

in power steering pump. on front (with pulleys) of engine, should have cap that says power steering.

How can you tell if your power steering pump went out? How can you tell if your power steering pump went out?

I need to know how to replace a power steering pressure hose for my 2002 dts Cadillac deville. Please help me if you can. Is this a hard job?? Thank you you, Emeel

HOW MANY POWER STEERING HOSES ON A DAEWOO LEGANZA 2000

The system uses regular power steering fluid.

Where d oyou poor the power steering fluid for 2000 acura tl

How do you remove high pressure power steering hose 2000 odlsmobile intrigue

unscrew the old one, then screw the new one in..?

the cam sensor is under power steering pump! remove pump then set aside,do not remove any power steering hoses, cam sensor is reachable now!! take out bolt that holds it in place,pull straight up to remove..

The power steering reservoir is on the passenger side behind the engine compartment.

where is the power steering pump on a nissan vanette 2000 2.3 d

camshaft sensor is under power steering pump. remove steering pump, then set aside do not remove hoses. sensor is down, remove one bolt that holds sensor in, then pull up on sensor to remove.

if you do it yourself,you only pay for sensor!! to change sensor on a v6, remove power steering pump and set aside do not remove hoses,sensor is under pump!! remove hold down bolt then wiggle it out!!

It is part of the steering gear.It is part of the steering gear.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.