To change the rear sparkplugs on V6 engine you will have to tilt the engine. Basicaly, remove main bolts from front engine torque struts and tilt the engine using pry bar. Once engine is tilted place one of the bolts trough the slave hole on the driver's side torque strut and bracket. Do not disconnect any wires or hoses but you might have to remove the coolant recovery bottle and set it aside. Also, you will have to remove air duct.
The 1987 Oldsmobile Cutlass Supreme was rated 350 horsepower with the with the V8 engine. It was last year that the Cutlass was a rear wheel drive vehicle.
The Oldsmobile Cutlass Supreme was an intermediate-size car produced by GM for the U.S. market. The Supreme sat atop the Cutlass line, beginning as a trim package and eventually becoming its own model name. The popularity of the Cutlass helped drive Oldsmobile to a million sales for the first time in 1978. More than half were Cutlasses. Production of the rear-wheel drive Cutlass ended in 1987. The last car to wear the Cutlass badge was a smaller, front-wheel drive car that left the line on July 2, 1999. It was replaced, indirectly, by the Intrigue.
you will have to drop your gas tank its inside the tank drive safe
you get in and drive
Remove the oil pan, unbolt the pump, install the new pump,the pump drive is off the bottom of the distributor and must be aligned to go in properly.
You have to remove the passenger side wheel, and inner fenders, then the drive axle and heat shield, then you can get at it. From underneath.....sorry.
The serpentine belt is broke or loose. Replace the belt
I have 2 of these cieras and NO they are front wheel drive, the cutlass supreme is real wheel drive
1967 oldsmobile cutlass
The both body styles, the 78-81 A-body and the 82-88 G-body of the rear wheel drive Oldsmobile Cutlass were available with aluminum hoods (RPO T45). Information came from the 60th Edition of the Hollander Automotive Interchange Manual.
yes it is a front wheel drive car, both the quad 4's and both the 3.1 and 3.4 L v-6's. all front wheel drive.
Insert a 3/8 breaker bar or wrench into the notch on the tensioner and pull upwards (towards back of the car). Then you can change the belt.
it's called a serpentine belt.
No there rear wheel drive rims are different than front drive rims
It's on the back of the engine....and hell to get to. Better off taking to a garage. I just broke mine off. Now I have to drop the oil pan and drive it back out.
If it's a 1990-97 model, yes.
Rev servo inop for some reason. Takeit to the trans shop.
It's rear wheel drive so you want to tow it with the rearend off the ground.
The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.
It could be a few things hub bearings, brakes, ball joints or possibly the CV axle. I would have it checked and then fix the problem at home if it is within your ability.
No water in the radiator
You don't really need to reset the computer. It does have base programming. However, it is recommended to take the car out and drive it about 10 miles. Some of this needs to be at highway speed. This will help it to "learn" the exact settings it needs. That should do it.
I am the owner of a 94 cutlass and it will not shift in reverse ,it will however shift into drive if i rock the car....can you tell me whats wrong or how to fix it please..my email is firstname.lastname@example.org