Requires two person team. Step One: Look at serpentine belt diagram on front of engine. Arrow points to idler tension pulley. (Front Left side of engine) Loosen this 15mm bolt. Step Two: Loosen Idler pulley bolt - 15mm. Step Three: One person push down on idler tension pulley with tire removal tool or cheater bar on front left of engine while second person lifts belt off alternator. Step Four: Remove Idler pulley and replace with new one. Tighten bolt to idler pulley Step Five: One person push down on idler tension pulley with while the other fits belt on alternator and around idler pulley. Step Six: Make sure belt fits as noted on belt diagram and Tighten bolt on idler tension pulley (front left side of engine). Approximate time: 10 minutes
How do you remove the interior rear door panel on a 2004 isuzu ascender?
how do you change the serpentine belt on a 2001 Rodeo
where are the spak plugs located on the 2005 ascender?
I replaced the engine idler pulley that I bought from Autozone for about $17 and eliminated the noise. I initially thought the bearings on my alternator were going out but when I replaced the pulley all the whining noise disappeared. Good Luck!
245/65R17
How do you put on a serpentine belt on a 2002 Isuzu axiom
switches for my aircondition Isuzu ascender
The wiper sizes and attachments will vary based off of the year of the Isuzu Ascender. See sources and related links below to lookup wiper information by vehicle year.
The Isuzu Trooper has a diagram for how to route the serpentine belt under the hood. The diagram is located on top of the fan shroud on the left side of the hood locking latch.
According to my 2006 Ascender owners manual the oil capacity with filter is 7 quarts. This is for the 2006 4.2
under the back passenger seat in a 04 2 row
2003 izuzu anscender 6 cylinder