there should be a routing diagram right under the hood, if not take a cell phone picture before replacing it so you know how to route it. You will see a tensioner, something that the belt goes accross and normally spins when the engine is running, you will need a 15mm wrench, just stick it on this and pull back, it should relieve the tension on the belt enough for you to remove the belt, you will then have to reverse this procedure to put the new belt on... Should take less than 5 minutes on a V6 because there is plenty of room, if you have a V8 it will be a little tougher
diagram for serpentine belt on 1996 Pontiac Bonneville se
235
it is located in the gas tank.
Yes
well you can change the entire rear hatch with that of a trans am's but I dont think it would be worth the the money to convert the car into a trans am style car.
I have a 1996 Firebird and it has 4. Two in the manifolds and one before the catalytic converter and one after.
Sure. The Firebird and TA are about the same car. It's mostly all cosmetics and a bigger engine. Just change all the "stuff".
how do you chance a serpentine belt on a 1996 ford escort
should be under a cover passenger side back of the car
backside of the intake manifold under the hood cowl.
'How do you change a fog light in a 1996 Pontiac Bonneville? ... How do you
1-6-5-4-3-2