Serpentine Belts
Pontiac Grand Am
DIY Projects

How do you change the serpentine belt on a 1998 Pontiac Grand Am?

454647

Top Answer
User Avatar
Wiki User
Answered
2007-12-05 06:02:07
2007-12-05 06:02:07

The 1998 should be the same as the 94 there is a tensionometer that a 3/4 rathet will fit it. If you are standing in front of the engine look to tleft where the belt is and towards the back. It looks like a 2-3 in wheel. Put your ratchet or breaker bar in the square and pull this should loosen your belt

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


I have a 1998 Pontiac Grand AM GT that coolant sensor went bad. So how do you change it with out breaking the coolant

are you trying to change the entire headlight assembly? or just the bulb.

You will have to drop the oil pan to access

Where is the starter on a 1998 Pontiac Grand Am, 6 cylinder

drive cycle for 1998 pontiac grand prix, 3.8 engine, no super charge?

on a 1998 Pontiac gan am ,they do not have a pcv valve.

See related question and answer at: http://www.wikifaqs.com/Q/How do you fix a 1998 Grand Marquis serpentine belt

depends on the engine size.... i have a 4cyl and it is on the lower left side of the front of the engine. you should see it attached to the serpentine belt.

You can easily get all of the color codes for every wire on the 1998 Pontiac Grand Prix. Pontiac has an official website homepage that has all the information on it.

where is the location of the body control module on a 1998 grand am se

The emergency brakes are whatever your rear brake pads are.

how do you change a brake booster valve to a 1998 Pontiac transport

The torque of the 1998 Pontiac Grand Prix is 220 ft.-lbs. at 4000 rpm. This remained the standard for all sixth generation models of this car.

All 1985-1998 Pontiac Grand Ams take 19" replacement windshield wiper blades on both sides front.

This website has one. http://www.devicemanuals.com/guide/Automobile/Pontiac/Pontiac-Grand-Prix-Owner%27s-Manual-1998-==TVRFd01qSXc=.html

The warning lights on a 1998 Pontiac Grand Am mean that the vehicle's computer has detected a problem. This can range from low tire pressure to malfunctions within the engine itself.

You can change the serpentine belt by loosening the tensioner pulley. When the tensioner pulley is loose and the serpentine belt will become loose. Put the new serpentine belt on and tighten the tensioner pulley.

its above the serpentine belt on the lefth hand side of the engine

The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.

shifter interlock wiring schematic

In the main fuse box, inside the cabin.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.