CAUTION: Don"t let the tensioner arm snap to the freearm position, it could cause severe damage to the tensioner.
Belt tension is not adjustable. Belt adjustment is maintained by an automatic ( spring load ) belt tensioner.
REMOVAL:
(1) Disconnect negative battery cable from battery.
(2) Rotate belt tensioner until it contacts its stop.
Remove belt, then slowly rotate the tensioner into the freearm position.
INSTALLATION:
(1) Check condition of all pulleys.
CAUTION: When installing the serpentine accessory
drive belt, the belt MUST be routed correctly. If not,
the engine may overheat due to the water pump
rotating in the wrong direction.
(2) Install new belt. Route the belt around
all pulleys except the idler pulley. Rotate the ten-
sioner arm until it contacts its stop position. Route
he belt around the idler and slowly let the tensioner
rotate into the belt. Make sure the belt is seated onto
all pulleys.
(3) With the drive belt installed, inspect the belt
wear indicator. On 3.7L Engines the gap
between the tang and the housing stop ( measure-
ment A ) must not exceed 24 mm (.94 inches).
next to the cylinder that is closest to the serpentine belt
Serpentine belt, accessory drive belt.
You can obtain a serpentine belt diagram have most Chrysler/Jeep dealerships. The serpentine belt diagram can also be found at most auto-parts stores.
it is adjusted throught the power steering pump loosen the adjuster bolts remove belt and reverse
How do you change a serpentine belt on 2006 Envoy
I need a routing diagram for the serpentine belt on a 1998 Jeep Wranger, 4 cylinder, with air conditioning
its self adjusting
not from the factory
how do you change serpentine belt gm 3.4 2003 venture
How Do I change the serpentine belt on a 1989 Cadillac Eldorado ?
A 2002 Jeep Liberty has a timing chain.
90,000 miles. 144,000 km