The starter motor is located under the car. There is three bolts holding it to the side of the transmission. There is also a bracet being held on by the bolt which is connected to the E.G.R. tubes. Just undo the the three nuts and pull the E.G.R. bracet off then undo the power line to the starter and you should have the starter in your hands. Before you do anything though disconnect the + batterie terrminal.
Disconnect the - battery cable Raise and safely secure vehicle Disconnect wiring harness from starter Remove 2 mounting bolts drop starter
Disconnect the - battery cable Raise and support vehicle Disconnect wiring at the top of starter Remove starter mounting bolts Remove starter
First what is wrong with you headlight switch on your 93 topaz.
picture of the fan relay for 1993 mercury topaz
The 1994 Mercury Topaz has a chain and not a belt.
Either the ign. switch is faulty, or the starter is faulty Or the starter solenoid is stuck closed, so the starter is constantly engaged and getting voltage from starter relay. If so you would need to replace the solenoid.
starter motor is below and to the right of oil filter
Looking at the front of the car, down around the oil filter.
how do you change the starter on 93 525i BMW
First what is wrong with you headlight switch on your 93 topaz.
The solenoid is attached to the starter. Replace the starter.
I need to know how to change a starter on a 93 Chevy z71 Unhook battery cables from battery, take the ground wire off starter, take power wire off starter, take the 2 bolts out of starter and should come right out
Disconnect the battery. The vehicle will probably have to be raised to reach the starter. The starter has two or three bolts holding it in, and wiring attached. Remove the wires remembering where to put them back. Remove the bolts and pull starter out.
Look here: How do you change the starter on a 1996 Toyota Corolla?Prizm and Corolla engines are the same.
Remove - battery cable Raise and support vehicle Remove wiring harness at the top of the starter Remove mounting bolts Remove starter
The starter relay is on top of the starter.
Disconnect the battery cable. Remove the bolts that hold the starter in place. Disconnect the wires. Instahlation is in reverse.
take it to a dealer
Disconnect the - battery terminal Raise and support vehicle Disconnect the wiring harness at top of starter Remove mounting bolts Drop starter