answersLogoWhite

0


Best Answer

You will need to swap out the entire gauge cluster. You cannot change just the temperature gauge. Remove the center Phillips-head screw under the windshield wiper switch & the center screw underneath the headlights switch. Tilt your wheel all the way down (if you have the tilt steering option). Firmly but gently grab the headlight and wiper switches, and pull toward you. The plastic piece around the gauge cluster should "pop" out. Once the plastic pulls free of the clips, disconnect the harnesses from the wiper and headlight switches. You will then find four small bolts holding the gauge cluster to the dash. Remove them. The gauge cluster will then pull out easily.

The best way to find a replacement gauge cluster is in a junkyard. There are a lot of Berettas and Corsicas there nowadays. Note that the odometer is included in the gauge cluster, and it may be illegal to misrepresent the mileage of your car if you're planning on selling it. Try to find a cluster with similar miles. Note: Adding a few more miles is morally better than less miles. ;-)

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the temperature gauge in a 93 Beretta?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

On a 93 jeep grand Cherokee Laredo if the temperature gauge is not working what could it be besides the gauge?

If the temperature gauge is not working, one thing it could be besides the gauge itself is a blown fuse. Another possibility is a loose or broken wire on the gauge.Ê


Where is the of the temperature gauge sending unit on 93 Mazda mx3?

There is a coolant temperature sensor and a temperature gauge sensor. the coolant sensor is located on driver side of the cylinder head. screws right into it, and the temperature gauge sensor is on the front side of the cylinder head right under the distributor. hope this helps


Where is the temperature gauge sending unit on a 93 corvette?

The temperature gauge sending unit is normally located on the p[passenger side head unit. It is located very closely to the number six cylinder plug.


Where is the starter on a 93 beretta?

it should be right by your oil pan


1991 skylark v6 no reverse drive L1-L2 OK?

have you tried your reverse band. my 93 beretta has no reverse and that's what is wrong with it.have you tried your reverse band. my 93 beretta has no reverse and that's what is wrong with it.


Will a 93 beretta 2.2 l motor work in a 96 beretta 2.2 l?

If the 8th digit in VIN of both cars are the same, then yes.


How do you fix a temperature gauge in a 93 Chevy van G20 series?

To fix the temp gauge check the temp sending unit first. A bad sending unit is a common problem with the temp system.


Distributor cap for 1993 Chevy bereta?

The 93 Beretta does not have a distributor, it has coil packs.


93 Chevrolet Gas gauge stays on full?

The gauge, wiring or sending unit is bad.


Does anyone have the fuse box schematics for a 93 Chevy Beretta with a missing fuse box cover?

Autozone.com has a fuseblock diagram. Our '93 Beretta is not here for me to go put the fuse block cover on the scanner (fuel delivery problem....), but go look that up. Fuses is called "circuit protection" after you get through all the narrowing it down to 1993 Chevy Beretta Chassis Electrical....


What gauge clusters can fit into my 93' Honda civic?

your ma


When do you have to know how to change percents to fractions?

To change % to fraction: Divide the % by 100% Example: To change 93% to fraction: 93%/100% = 93/100