i dont know go to the shop
Strong impact wrench and 22MM socket
With a self adjusting tensioner pulley, there is no adjustment for tension.
very simple, there is a tension pulley on top of the AC/Compressor loosen the center bolt on the pulley and the adjusting bolt on top of the tension pulley and simply push the pulley down until the belt comes loose.
The 1989 Toyota Corolla serpentine belt can be tightened or loosen with the tensioner pulley. Pry to the left on the tensioner pulley until the belt is tight. Tighten the tensioner pulley.
u need to relaese tension on the tension pulley. this is usually done with a long socket wrench handle. when u release tension and remove belt you then release tension on pulley until you have routed new belt . you then move tension pulley again until you can put belt on it, then release pulley and it will automatically provide correct tension
Locate the idler pulley and release the tension. Remove old belt and replace it with the new one (there should be a sticker on the underside of the hood or on the radiator housing showing the path for the belt) and re-tighten the idler pulley.
I used a breaker bar for the tension pulley to relieve the tension to remove the belt, I think there are three bolts that hold the tension pulley on, just remove them and reverse the procedure to install. Follow the diagram that is either on the inside of the hood or on the radiator cover on how to thread the belt back on the pulleys.
The easiest way to access the pulley is to remove the front right wheel and fender liner. The pulley will be right behind the liner.
You don't. The pulley is pretensioned by the manufacturer. If the belt tension is incorrect, the pulley must be replaced.
Release the tension with tension pulley. Follow belt pattern printed on a sticker under the hood
take the pulley nut off the alternator....the pulley is split.....shims between the two pulley halves adjust the belt tension
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.