to make it easier, take off the airbox/intake, remove the IAC connected to the throttlebody, the TPS is connected to the throttlebody by 2 Phillips screws. Be sure not to mess up the head of the screw it'll be impossible to take off.
Attached to the throttle body
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
The throttle position sensor is in the throttle body.
the throttle position sensor should be on the side or the bottom of the throttle body. it is a little black or silver piece with 2 screws on it
Surging or stuttering at a particular pedal position such as "the sweet spot" when cursing.
The function of a throttle position sensor is to monitor the position of the throttle in an internal combustion engine.
The throttle position sensor is located on the throttle body at the end of the throttle shaft.
The throttle position sensor is located on the throttle plate.
The throttle position sensor is on the throttle body.
The throttle position sensor is on the throttle body, opposite of where the cables attach.