Want this question answered?
Where is the speed sensor located on a 1997 Oldsmobile Aurora
Throttle position sensor
Must remove the throttle air intake hose from throttle body. Then disconnect the wiring and remove the sensor and spray with mass air flow sensor cleaner.
no
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
unhook your battery. remove sensor. no setting is needed.
throttle position sensor is located on the throttle body oposite of the throttle cable. Should be held on by 2 screw and a 3 wire plug.
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
the throttle position sensor should be on the side or the bottom of the throttle body. it is a little black or silver piece with 2 screws on it
i found it easier to remove the throttle body to access the tps sensor. the screws can be somewhat difficult to loosen due to corrosion and position of the sensor.
On the 4.0L, a camshaft posion sensor that is part of a oil pump drive housing.On the 4.0L, a camshaft posion sensor that is part of a oil pump drive housing.