In the front, it's the whole hub assembly which means it has the wheel studs on it. There are 4 bolts from the back that hold it to the upright. The caliper bracket needs to be removed, and it is held on bt large Torx bolts that are on there really hard. There's a wheelspeed sensor that needs to be taken out of the way too. On the back the wheelspeed sensor is inside the part making it more expensive.
how do you change the radiator in 96 chevrolet lumina
wheel bearing hub is common cause.75 to 100 dollar part normally.
No, The bearing is what your wheel rolls and sits on. No bearing mean Wheel will come off.
loose wheel hub screws.. the brake housing is rubbing against the inside of your wheel because it is loose
Might be that the nut holding the wheel bearing needs tightening or that the wheel bearing needs replacing. Going to have to take it apart to get to the bottom of this one.
With the proper tools and knowledge, 1 hour.
you dont rotate it you have to pull the altnator off to change them
Possibly low of lube, or worn ring gear and pinion. Another possiblility is a defective wheel bearing or axle bearing.
Yes. But they use different wire harnesses and ECM's. The 93 has less electronics than the 96 year Lumina's.
yes as long as it is the same size 3.1 or so on and you will have to change the one exhaust manifold i know that for sure because i just put a 96 3.1 liter into a 97 lumina.
remove the metal hinge or use a machete :)
This website is a piece of garbage. It has more questions then answers.