Take the 2 screws out just above the guage cluster on the trim that goes around the outside of the dash. Put your steering wheel all the way tilted down. Take a small flat screwdriver and pry between the lower part of the trim were it connects to the dash and it will pop the clips out. Once you loosen those it should move away from the dash some. Take a small flat screwdriver and push the connecting clip from the headlight switch and it all should come out. Put the new dimmer switch in and reverse the process.
How do i find the instructions for changing out the fan switch assembly in a 2001 Mercury Cougar?
how can you start a '89 mercury cougar with a broken ignition switch?
How do I change the dimmer switch on my 1993 corvette?
Why are you replacing the switch? If the fan works only on high speed, replace the fan resistor. There was a TSB for this.
how to change dimmer switch on 1997 Honda accord
help mower!
Usually a switch will only let you choose between ON and OFF, but a dimmer switch will let you change between Brighter or Darker.
According to the 2002 Mercury Cougar Owner Guide : The fuel pump shut - off switch ( inertia switch ) is located in the drivers foot well , behind the kick panel ( there is an access hole )
A "dimmer" switch will change the brightness of lights.
it is located on the light a switch that says 12sec on and off
The dimmer switch is located near the floor on the left side of the steering column. The dimmer switch and ignition switch are secured by the same two screws. The dimmer switch will be the one on top. Loosen and remove the screws, disconnect the wiring harness from the dimmer switch and replace with the new switch, complete the assembly in reverse order.
The fuel pump inertia switch is in the drivers footwell behind the kick panel ( there is an access hole ) in the 1999 Mercury Cougar