0
use a piece of modeling clay,( you can get any wal-mart craft section). place on top of the intake valve relief . place the head on the motor with a few bolts and with a week spring and your valve in place, compress the valve and measure the clearance with a dial indicator and this should tell you thickness of the head gasket you need.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the valve clearance on Honda trx 350?
The Valve clearance for a 1993 TRX Honda Fourtrax is 0.03 on a feeler gauge. 0.03 -intake 0.03-exhaust
What causes your 350 Chevy to not have compression on number piston?
Type your answer here... Burnt intake or exhaust valve, hole in piston, broken piston rings, bad head gasket, valve spring broken.
What should you do to the heads on a 350 Chevy for a cam with 292 dur and a 501 lift?
I wouldn't be so worried about the heads as the pistons. Make sure you have enough clearance so that an open valve won't hit a piston.
What is the valve clearance for a 2006 Honda rancher 350?
.15mm or .006 inches when the engine is cold. Check out my bio page if you need help with the procedure.
What is the Valve clearance settings and adjustment for a 1987 Honda 350 TRX ATV?
.003 on intake and exhaust
What will the heads have to do with a 350 Chevy smoking and using oil?
Valve guides and/or valve seals can be worn. Allows oil to get into the combustion chamber.Oil consumption and smoking are signs of either bad piston rings or bad valve guides/valve seals.A compression check on each cylinder can help determine which.
305 crank in a 350 block what is it and will it fit?
it should de-stroke it to something around a 327. it will fit but be sure to check for crank to piston and piston to head cylinder top clearance to ensure you don't run into engine detonation. ummm no 305 and 350 have same stroke a 400 crank would make it a 334... same main and rod journals also stroke is 3.48
Why does 1993 Chevrolet 5.7 oil smoke under load already changed intake gaskets and checked compression?
check the piston rings but that a typical thing any 350 dose check the piston rings but that a typical thing any 350 dose
Is a cam lift of 539 going to hit the piston in a 350 Chevy?
It might. Better check first.
How do you fix engine blowby coming from the valve covers on a Chevy 350?
The problem could be valve seals or excessive piston ring blowby. You could try changing the pcv valve on the valve cover and check the line going to the intake plate to make sure its not stopped up or the intake plate isn't stopped up. However, it most likely means that the piston rings are worn out are broken. Time for a engine rebuild. That is the only way to fix that problem.
What is the clearance for a valve adjustment using a feeler gauge for a stock Chevy 350 motor?
Stock 350's have hydraulic lifters, so feeler gauges aren't needed. Get yourself a Chilton's manual or similar and read up on the valve adjustment process.
Valve lash 350 small block?
you would probably want to call your local machine shop or part store.....but ,the valve lash adjustment for a Chevy 350 with hydrolic lifters,I believe, starts with the #1 piston at top dead center...tighten the intake valve rocker arm just enough so that the plunger inside the lifter is just below the snap ring...then go to the next piston in the firing order for the intake valves...when all the intakes are done you should be at #6 piston tdc...then go through the same steps with the exhaust valves...again I would double check, it's been a while. good luck
