To check the code on the 2004 Dodge Durango you can also KEY from the on to start position 4 times (eg. Off to start, off to start, off to start, off) and the code should show up in the odometer reading. For example I just had the MIL come on and I did the KEY thing and found the code was P 0456. If you don't see something try turn the key again three times and then on the fourth turn leave it in the start position. It should show up. the durango need to be pluged into a type of computer that can communicate with the powertrain control module (pcm) if you have an engine malfunction light on. the drb will give you a code, the code will give you an area of the vehicle to inspect ie p0456 (large evaporitive emidssion leak detected) then you will have to inspect that system to find the cause of the code
With a scan tool,
With a scan tool
check your answer
See link below for a complete list of OBDII codes.
What causes ticking, check engine light, and the check gauges sensor to come on in a 1999 Dodge Durango 5.2L SUV?
With a scan tool.Some auto parts stores will check them for free.With a scan tool.Some auto parts stores will check them for free.
Codes are cleared and computers are reset with a scan tool.
turn the key to on and then off 4 times. any codes will appear in the mileage box. If there are no codes, it will read p done. If there are codes it will show P??? and then P done.
Have the codes read, and fix the cause. May be the rear axle speed sensor.
Check the starter! It happened to my 2000 dodge durango too.
Dodge Durango was created in 1998.
Check valve cover, it has a vac hose if that helps.