0
To change Transmission Fluid on a Acura 3.2 TL you must first check the existing fluid level when the transmission is hot which takes 15 to 20 minutes of driving. Next you will need to dip the dipstick in the transmission fluid to check the level which should be between the third and second level of the dipstick. Use a funnel to add transmission fluid if necessary. Next start the engine and shift into each position and then apply the parking break and turn the engine off. Recheck the transmission fluid and add more if necessary.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is the transmission fluid capacity of a 1998 dyna wide glide?
32 ounces
How much transmission fluid does a 2007 Harley Davidson Ultra classic hold?
32 ounces
How much oil is used in the transmission of a Harley Davidson Road King?
32 fluid ounces
Is kerosene alkaline?
technichally it is a cetane like diesel fuel and with transmission fluid at 32:1 32 ounces kero to ounce transmission fluid you may be able to use it in a diesel engine.
How many quart are there in one oz?
1 quart = 32 fluid oz US or 40 fluid oz UK.
Can you use water instead of transmission fluid in the radiator in an emergency?
You should never use transmission fluid in a radiator.You can use water without antifreeze in a radiator, but if the engine gets below 32 F (0 C) the water will freeze and severely damage the engine.
How many quarts are in 1 fluid ounce?
1 quart is 32 fluid ounces.
How many fluid ounce are in a quart?
There are 32 fluid ounces in each quart. There are 40 fluid ounces in an Imperial quart.
How many fluid ounces in a quart?
1 US quart = 32 US fluid ounces
How many fluid onces make a quart?
There are 40 fluid ounces in one quart. Therefore, 2 quarts is equal to 2 x 40 = 80 fluid ounces.
How many fluid ounces 1quart?
32 US fluid oz
How do you change the transmission fluid on a 2001 honday passport?
Place a large drain pan under the oil pan.Remove the transmission oil drain screw (2) and drain fluid.Tighten drain screw (2). Torque: 38 Nm (28 ft. lbs.)Remove the transmission overfill screw (1) and fill transmission through overfill screw opening, using DEXRON III ATF. NOTE: Add transmission fluid until it flows out over the overfill screw opening.Let engine idle until a fluid temperature between 32°C (90°F) and 57°C (135°F) is reached.Add transmission fluid until it flows out over the overfill screw opening, then close the overfill screw (1). Torque: 38 Nm (28 ft. lbs.) NOTE: To prevent fluid leaks, the overfill screw and oil drain screws gasket must be replaced each time these screws are removed. NOTE: Check transmission fluid temperature with scan tool.
