To clean the inside headlight lens on a Ford Ranger just simply remove the cap and clean.
The relay is located inside the headlight housing. Loosen the screw on the trim ring around the headlight, pull the trim ring and then pull the headlight. The flasher relay will be either rectangular or round with two prongs. Good luck
Yes, a round headlight will fit on a Yamaha Seca. Just be sure that the model and specifications match what will fit into the mounting brackets.
its the little round dial next to the headlight switch turn the dial all the way up
On a 1997 Ford Ranger : The Mass Air Flow sensor is INSIDE the round plastic housing between the engine air filter ( cone shaped ) and the big rubber engine air intake tube ( you will see where the wires go inside the plastic housing )
Just round it Just round it
Not sure exactly what the bike looks like, but I have an XV920 Yamaha that had a square headlight and digital dash and swapped it for a 750 Virago round headlight and a 77 750 triple speedo. Anything is possible if you got tools and some imagination.
i like big round donuts
Under the hood, there are round turning knobs that allow you to manually lift your headlights. Turn them all the way (I don't remember if it's clockwise or counter-clockwise) and you should see the headlight opening up. Once it's open, it should just be a matter of unscrewing the outside bracket (leave the inside bracket that's surrounding the headlight intact) and replacing the headlight. Replacing the headlight is not an easy thing to do but it's not real complicated. ed by a female!!
Look to the back of the headlight assembly. There will be a round sleeve where the wiring goes into the headlight. Twist this counterclockwise to turn the head light bulb assembly. Pull back on the assembly to remove it from the headlight casing. Replace with new headlight bulb.
When you open the hood look above the headlight for two round plastic caps. Pull these upwards, it releases the light assembly.
you don't replace the bulb, you replace the entire " round "headlight with the bulb insideAnswer #2:Remove the center grille (if you have the dual-round grille, it's one piece; skip next step).Remove the side, headlight grille surrounds.Unplug the wiring harnesses from the the lamps.Remove the headlight screws (don't confuse these with the flat-head adjustment screws).Pull the lamp out.Installation is reverse of removal.
If you mean that one of your headlights is out then all you have to do is replace the bulb that's inside of it. Pop your hood and look behind the headlight assembly and you'll see some wires in the middle of it that go through a round black sort of casing. That goes to the lightbulb. All you have to do is {carefully} twist it, take it out and replace the bulb. Good luck.