OBDII codes are cleared with a scan Tool. I recently had 3 vehicles with the CEL/SES on. Although a parts store read the codes for me and I affected the repairs, I still needed a OBD2 Scan Tool to clear the codes. I purchased AutoEngnuity's ($250 with tax)OBD2 PC-based Scan Tool software online which comes with an OBD2 interface module (USB, or RS232) to connect to the vehicle. The device has already paid for itself, and it can do more than just read, and clear codes.
typemake, model, code into your computer .i have a list of codes and there is no p1105 code, clear your machine and try again
Remove the neg battery cable for 30 seconds. This should work on all pre '96 cars as long as there are no more problems with the car.
Yes there are clear headlights available in the automobile market depending on the model
I found the answer here: http://www.mazdaforum.com/forum/mazda-mx-3-mazda-mx-6-25/water-leak-17642/
make sure you clear all the MIL codes before you do a repair to fix the problem otherwise its just going keep throwing the same code..
disconnect the negative terminal of your battery and press on the foot brake for 10 seconds or use a scan tool to clear the codes
The P0300 is a multiple miss-fire code. The P1130 & P1135 are fuel air metering codes. Generally speaking you want to fix the first fault code in the list if you pull multiple codes at once. One code can cause other codes to appear. Fix the multiple miss-fire problem, clear the codes and see if the other two comeback.
Either buy a reset switch from a motor factor or get your local dealership to clear it.
Take it to a dealer. The air bag won't work while the light is flashing.
From my experience with RX7s, the easyest way is to drop the tank so you have enough room to get at bolts and clear the lenght of the fuel sender.
Since it is OBD11 it requires a scanner to retrieve the codes. Most parts stores will read then for free. you can use a car scanner to clear it out.
The light is on because there is a malfunction in the system. You need to have the codes read to no possible causes. After the failure is repaired the light will clear itself. You can not shut the light off when there is an active failure.