First, in order to accomplish this task, be sure the plastic flange fits the opening in question. It this is new work and anchor bolts or anchorbolt holes are not already in place, fit the flange to the lead drain line as you want it to go and by this guide, using a cement bit, drill holes in the cement(assuming the basement floor is cement). Two holes are required. After the holes are drilled, force lead inserts into the holes. These are to screw the anchoring bolts into to hold the flange stable. Choose the correct lead inserts and the side drill bit to match. Any hardware store can match these up for you. The remount the flange, through the proper holes in the flange, the ones you used as a guide for the holes, then insert the ancholr bolts and tighten down. It Holes are already in place and no lead inserts are already in the holes, simply obtain the proper inserts, bolts and Voila! do according to the above, simple yes?
Most likely not, depending on the type of pipe you can find an inside flange to fit.
To allow floor flange bolts to have a place to fit and to anchor the flange to the cement /wood decking
Not. There's no way to connect a WNF to an RTJ flange.
A compression flange is used to connect a toilet to the sewer line.
The flange adapter is a part that is used to adjust the size to the next piece so it will connect. It can be made out of any material.
Most likely not, depending on the type of pipe you can find an inside flange to fit.
To allow floor flange bolts to have a place to fit and to anchor the flange to the cement /wood decking
Not. There's no way to connect a WNF to an RTJ flange.
A compression flange is used to connect a toilet to the sewer line.
Usually toilet flange is glued down onto plastic drain pipe. There is a toilet flange that can be glued inside of plastic drain pipe also.
The flange adapter is a part that is used to adjust the size to the next piece so it will connect. It can be made out of any material.
The flange adapter is a part that is used to adjust the size to the next piece so it will connect. It can be made out of any material.
The bolts that come from the drain and run to to toilet help to alaign proper drainage and seal the toilet. You do not want to do the bolts set in cement idea...
With the Allen key supplied with the disposal
Floor flange, cast iron ,brass with floor flange bolts (brass) wax gasket and make sure the line is vented
raised face valve can have a flat face flange. raised face valve is actually different in its cross-section rather than its flange face.
You can buy an adapter for that in good plumbing stores, about $5.