Sorry no after market MAF best bet customization I took the lid that the MAF screws to and used a cutting wheel to cut around the screws in the top then it leaves a ccup for a rubber gromet to go around then i cut the green box of the MAF and extended the wires and put the box somewhere eles then shove the MAF into a cold air filter it works great.
There is no Intake Air Temperature sensor on a 1995 only 96 and newer. If you are asking because you are putting some sort of performance module on it then you need to hook that up to the Coolant temperature sensor which is located next to the thermostat and it is a two wire sensor.
The air intake temperature sensor can be found on the top of your manifold intake. The sensor will be right in the middle of the intake manifold.
The intake air temperature sensor is located on the mass air flow sensor on the intake. There are five wires attached to the sensor.
The IAT (Intake Air Temperature) Sensor is a Two (2) Wire sensor located close to the intake.
the intake sensor located with the air flow sensor.
On the rubber air intake line between the Filter box and the Throttle body. Round device, pops right out without tools.
The IAT is part of the MAP sensor on vans before 2001. In 2001 they started putting it near the air box.
The Intake Air Temperature sensor is either part of the Air flow sensor, or a separate sensor in the intake pipes not far from it.
the intake air temp sensor for an 07 Silverado is built into the MAF sensor. The MAF is located on the air intake hose.
intake air temp sensor
There are two, the ambient air temp sensor on the cold air intake just before the filter. And the Intake temp sensor on the intake itself (throttle body after the MAF.)
it is in the intake manifold by the throttle body and the map sensor. it is a two wire sensor