0
What else can I help you with?
What do the bands on resistors mean?
in simple terms, band represent numbers, ex:- 10K resistor have different colour code and that is difference from 5k resistor. if you type in google 'resistor colour code' that will describe how to calculate a resistor value. thanks
What are nominal values?
Nominal values are the values that a component is specified to be. For example, the nominal value of a 10K resistor is 10K. Its actual value may vary, though, based on its tolerance.
What is the volt drop across a 10k resistor with a 5 volt supply?
If there is nothing else in the circuit, then the voltage drop across the resistor will be the full supply voltage of 5 volts. The size of the resistor does not matter in this case - it will always be 5 volts.
A resistor of 10k ohms resistance with tolerance of 5 percent is connected in parallel with another resistor of 5k ohms resistance and 10 percent tolerance.what is tolerance limit of parallel network?
6.67%
What is different between the resistor and pullup resistor?
A "pull-up" resistor is a resistor used to to perform a specific electronic function - it is not a different type of resistor. A very small current flows through a pull-up resistor so it does not need to be high wattage (1/8 watt is generally fine). The value of a pull-up resistor depends on the resistance of the sensor. If it is simply on or off (no resistance) then a typical pull-up resistor might be 10k ohms.
What is the value of 1E5 resistor?
According to the EIA-96 system which applies to SMD resistors, it means 10K (10,000 ohm), 5% tolerance.
Can you measure the physical size of a resistor to determine its wattage?
there might be ways to get the power rating by measuring the size of the resistor. but as the physical size of the resistor increases, its power rating also increases..
How would you connect a resistor in order to reduce an LED's applied voltage?
You could use the voltage divider rule to reduce the voltage. Using two resistors in series, the input voltage will drop across each resistor by an amount that is proportionate to the values of the resistors. If the 1st resistor is 10K and the 2nd resistor is 100K, the voltage drop across the 10K will be 10 times LESS than that of the 100K resistor. The total voltage drop across both resistors will be equal to the supplied input voltage. Work out the ratio of voltage you need from the total input voltage and use 2 resistors will that give you the same ratio. Connect the LEDs in parallel with the resistor the gives you the voltage you want. Use a MM to measure the voltage across the resistor before wiring LEDs.
What is the current across a 10k resistor and 20 volts?
First of all, current goes straight through the resistor, not across it.If the potential difference between the ends of the resistor is 20 volts,and its resistance is 10,000 ohms, then the current through it isI = E/R = 20/10,000 = 0.002 ampere = 2 milliamperes
How much voltage is required to cause 8mill of current to flow through a 10kilo resistor?
V = IR = 8x10-3 (8 mA) * 10x103 (10k) = 80v
Why you need to connect resistor in series for the practical voltage source?
A resistor is connected in series with a practical voltage source in order to determine the current produced by the source.
What do the colours on resistor mean?
The colored bands on a resistor represent the resistor value and tolerance. The first two bands indicate the significant digits of the resistance value, the third band represents the multiplier, and the fourth band (if present) indicates the tolerance of the resistor. By decoding these colors, you can determine the resistance value of the resistor.
