I just bougt the 2007 model and found a website that allows you to permanently or temp. disable the alarm. Hope this helps, because it was annoying the hell outta me, and as the site site, use at your own risk. You can Deactivate the Belt Minder two ways. First, you can deactivate it temporarily for your current "run cycle", that is after you have started your car and it's still running. Second, you completely deactivate the Belt Minder so that it never reminds you again, or at least until your reactivate it... The first method, temporary deactivation, or one time disable: After you have started your vehicle, buckle and then un-buckle your safety belt. Be sure to buckle back up.... This will disable the Belt Minder only for that ignition cycle. The second method, permanent deactivation: There are 9 steps you need to follow to deactivate or activate your Belt Minder system. Before doing so, make sure that: The parking brake is set. The truck/car is in Park (automatic), Neutral (manual). The ignition is OFF. All doors are closed. The driver's safety belt is un-buckled. The parking and headlights are OFF. Then follow these 9 steps: Turn the ignition switch to ON, but DO NOT START. Wait for the safety belt warning light to go OFF(1-2 minutes). Steps 3-5 MUST be completed within 60 seconds! Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. Turn on the headlights, turn off the headlights. Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. After step 5, the Safety Belt Warning Light will be turned on for 3 seconds. Within 7 seconds of the safety belt warning light turning OFF, buckle then un-buckle the safety belt. This will disable the Belt Minder if it is currently enabled, or enable the Belt Minder if it is currently disabled. Confirmation of the disabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds. Confirmation of the enabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds, followed by 3 seconds with the safety belt light off, then followed by flashing the safety belt light 4 times per second for 3 seconds again. After confirmation, the deactivation/activation of the Belt Minder procedure is complete
you press the lock button
disconnect the cable from the speaker behind the in the rear piller cover
Underneath the stearing wheel is a gray connector. While you have the door open disconnect it and the buzzer should go off.
The 2006 Ford Escape has 16 valves.
with your remote
The 2006 Ford Escape has a 5-speed manual.
The 2006 Ford Escape is a gas-powered vehicle.
The 2006 Ford Escape has an inline 4 engine.
The curb weight of the 2006 Ford Escape is 3347 lbs..
The 2006 Ford Escape has a 20.4 degrees angle of approach.
The height of the 2006 Ford Escape is 5 ft. 9.7 in. (69.7 in.).
The 2006 Ford Escape runs on regular unleaded.