If your state has State Inspection Laws, doing so will cause your vehicle to fail the inspection. You should always wear your seatbelt.
I know how to do it, but since I've picked up so many that have gone through their windshields because they failed to buckle up, I will not provide the answer.
The 'beltminder' is the most frustrating safety feature ever. It goes off in park with the car running. Don't tell me it isn't supposed to. It does. I'm tired of snyde people like the guy who previously answered, "I know, but I'm not going to tell you because I'm going to save your life blah blah blah." I was able to put a seatbelt on before the Beltminder, and I can continue to today. I am actually LESS likely to wear my seatbelt when I hear that god-forsaken beeping. I do not want my car to tell me what to do, and I don't need the seatbelt on when I'm eating Burger King and listening to the radio IN PARK. So, to all of you, "Just wear the seatbelt" people, please shut up, k? You suck. Thanks!
I have successfully disabled the "Beltminder" system on my Mercury Grand Marquis as it is very annoying to have it ringing a bell every 10 seconds (see below).
==============================================
Instructions to disable "Beltminder" in a Mercury Grand Marquis
Permanent deactivation: There are 9 steps you need to follow to deactivate or activate your Belt Minder system. Before doing so,
make sure that:
· The parking brake is set.
· The truck/car is in Park (automatic), Neutral (manual).
· The ignition is OFF.
· All doors are closed.
· The driver's safety belt is un-buckled.
· The parking and headlights are OFF.
Then follow these 9 steps:
1. Turn the ignition switch to ON, but DO NOT START.
2. Wait for the safety belt warning light to go OFF(1-2 minutes).
Steps 3-5 MUST be completed within 60 seconds!
3. Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled.
4. Turn on the headlights, turn off the headlights.
5. Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled.
After step 5, the Safety Belt Warning Light will be turned on for 3 seconds.
6. Within 7 seconds of the safety belt warning light turning OFF, buckle then un-buckle the safety belt.
This will disable the Belt Minder if it is currently enabled, or enable the Belt Minder if it is currently disabled.
How can i disable alarm activated on 1996 mercury villager Horn and location this part please How_do_you_disable_factory_alarm_activated_on_1996_mercury_villager_Horn_headlight_are_blinking_continously.
To disable the factory alarm on a 2000 Mercury Villager, put the key in the ignition and turn it halfway. Let it stay in the spot for 10 minutes and start the car.
Take out the battery.
Why, are you going to steal one?
i don't think that is a legal question...
You can't. It is part of the computers' programmings.
disconnect the cable from the speaker behind the in the rear piller cover
To disable the seat belt alarm on a Chevy Colorado, locate the alarm fuse. Pull out the fuse to disable the alarm.
that easy take out your alarm out your car i m sure your alarm will be disable
how do you disable rover 25 car alarm
How do you disable the alarm system on a 1998 yukok
You can disable the speed alarm by removing the speed alarm fuse. When the fuse is removed the alarm will not sound.