THIS DID NOT WORK ON MY 2007 CAMRY..ANY OTHER SUGGESTIONS??
Wear your seatbelt :)
By wearing your seat belt.
Buckle your seat belt.
get an old seatbelt from a junk yard and plug in into the seatbelt soquit
simply wear your seatbelt.
plug the seatbelt in.. the warning stops then ;-)
I don't know but the whole point of it is so it irritates you until you put your seat belt on. Its for your own safety!
Put on your seatbelt. It it is still chiming with your belt on, take it back to the dealer for repair. It is under warranty.
Buckel your seatbelt and it will go off. If it is not going off with your seatbelt buckled, then take it to the dealer for repair.
Well you should always wear a seatbelt but you can turn off the chime by simply grounding the wire lead at the seatbelt causing the electricity to flow through and the chime to turn off
Don't do it! There are possibly other circuits connected to the junction terminal where the chime is powered from. You could lose dash and/or tail lights.
To state the obvious - wear the seatbelt. There are reasons to disable the chime. 1. Turn key to accessories "on" 2. Wait for seatbelt light to turn off and then press the seatbelt release button 9 times. 3. The abs light then illuminates for 5 seconds, when it turns off, press the seatbelt release button 1 more time. 4. The abs light will blink to confirm the code was entered. 5. This must also be done on the passenger seat.
You can disable the seatbelt warning chime, in your Honda CRV, by removing the fuse. The fuse can be found in the fuse box in the engine compartment.
Under the driver seat is a wiring harness plug for the seatbelt just unplug it mine is an ext cab so it's easy to get to not sure on regular cab
Here is a couple of links to check out! One is a mechanical fix and the other is, well you decide :) http://www.tundrasolutions.com/forums/tundra/107489-diy-how-to-disable-seatbelt-chime/ http://www.tundrasolutions.com/forums/tundra/135468-diy-contest-seatbelt-chime-light-gone/
To turn off the seatbelt chime in 2006-2008 Dodge Rams and some other newer Dodge vehicles, follow this procedure: Get in the vehicle, close the door, put on your seatbelt. Start the engine, wait for the seatbelt light to turn off. Within 30 seconds of the light turning off, unbuckle and re-buckle the seatbelt 4 times, making sure the seatbelt light responds (turns on and off) each time you unbuckle and re-buckle the belt. Ending with the seatbelt BUCKLED, turn off your engine. If done correctly, you will immediately hear one chime to verify the programming. To re-enable the chime, simply repeat this procedure. NOTE: Although the seatbelt chime will not chime constantly if your belt is not buckled while driving, it WILL still chime when you first start your engine, and the seatbelt light will stay on to remind you. The light can be deactivated also, but it is a much more complicated (and I feel unnecessary) procedure. WARNING!!!: DO NOT deactivate the seatbelt chime by cutting or splicing the wires to the seatbelt buckle under the seat. THIS WILL DISABLE YOUR AIRBAGS even if your belt is buckled!!! AIRBAGS are DEADLY if your belt is not buckled, so there is a sensor in the buckle which disables the airbags when the belt is not buckled. If you cut or splice these wires, you also disable that sensor. Turning off the chime using the programming option keeps your airbags working properly. Hope this helps, ENJOY YOUR DODGE!!! -Mike Vidal, Forked River, NJ
Put on your seatbelt. You should be wearing it!!! I work on a ranch and am in and out of the truck opening gates this link comes in handy
i don't know why you wouldn't want to wear a seatbelt but you could go to a junkyard and get the male end from another vic and cut it off the belt and place it in the offending seatbelt end
if you have the owner book that came with the vehicle, you can find in the book how to disable the door chime
insert the male end of the seatbelt into the female seatbelt receiver. This is best done while preparing to drive somewhere while the belt is across your body. It is also a lot safer and even mandatory in most states.
buckle your seatbelt
instructions to disable chime can be found in the ownere handbook that came with the truck it is disabled thru the computer in truck
The chime can not be disabled or removed.
You cannot do unless you will disconnect the bipper. If you do so you can loose warranty for your car, and do not pass the state inspection next time. Or you could put your seatbelt on........