Want this question answered?
the cool sensor is located under the throttle boby on the front of the engine. disconect the wiring harness and use a box wrench (19mm) to remove it
How do you remove the bottom front right airbag on a 2011 ford fiesta.
To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.
Coolant temperature sensor is located on the front of the engine. The coolant temperature sensor is a few inches above the thermostat housing.
easy two plastic screws under seat
Remove front driver seat . Disconect battery . Remove wheels . Take cluch rod off . Clutch falls out . Refit as removed
Find the ABS wheel sensor. Loosen the bolts that attach it to the suspension. Remove the bolts that hold the sensor to the wiring. Remove all other bolts. Remove the ABS sensor.
It depends on the vehicle and if it is a front or rear sensor, they are all different.
# The CKP sensor is located on the front side of the engine block # Unplug the CKP sensor electrical connector and remove the mounting bolt and remove the sensor
jack up front of car remove left front undercar cover sensor found under crank shaft pully remove connector and measure resisitence of sensor aprox 900 to 1800 ohms
first disconnect battery cables ,jack up front passenger side front end,disconect wire and positive battery cable, remove 2 boltsand that's it
The camshaft position sensor on your 2002 automobile is located on the front of the camshaft. You will need to remove the front engine cover to access the sensor.