Fuel Filters
Ford Windstar

How do you disconnect a stuck fuel filter from the outlet line on a 1996 ford windstar?

272829

Top Answer
User Avatar
Wiki User
2006-09-11 17:45:21
2006-09-11 17:45:21

I just encountered this again the other day... Just pull really hard! This will most likely pull a piece of plastic off the fuel line that you need - just put / push it back onto the fuel line.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

My oil filter is stuck on my 1995 Jimmy truck whats the best thing i can do?

User Avatar

You can unscrew your stuck oil filter with an oil filter wrench. If the oil filter wrench does not work, punch a metal rod through the oil filter. Turn the oil filter off with the metal rod.

User Avatar

They ate it or it go stuck in the filter. Check the filter and see if it's there. If not, it may have gotten stuck in the filter, staved and then when it washed out of the filter the fish ate it.

User Avatar

You just pull out the Horn relay/fuse.

User Avatar

The switch had a meltdown or the high speed relay is stuck.

User Avatar

cut the cable or disconnect the cable from the calipers

User Avatar

Chances are that there is a rubber O ring stuck in the channel the filter seats into. Remove the filter, take a scribe or something like a scribe and make sure there isn't an old O ring stuck up there.

User Avatar

old rubber gasket stuck to block or to much oil pressure regulated by spring above oil filter Filter not tight, hole in filter,....

User Avatar

check and see if the old rubber gaskit is stuck on the oil filter housing

User Avatar

I carelessly stuck my finger in the electric outlet and received quite a jolt.

User Avatar

Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.

User Avatar

Trouble code P1518 means: Intake Manifold Runner Control Stuck Open (Bank 1)

User Avatar

silver box on right side of fan shroud. you can disconnect there.

User Avatar

If it's stuck in defrost your battery died and messed up the computer. Disconnect battery for 5 or more min. My 96 cooled and heated ok but was stuck in defrost

User Avatar

The contactor on the outdoor unit is probably stuck. Disconnect the power to the indoor unit, then disconnect the power to the outdoor unit and take a look at the contactor.

User Avatar

No fuel in tank; clogged line at/in the fuel tank; clogged fuel filter; carburetor needle valve is closed, fuel float stuck closed. Disconnect fuel line at carb, if you have fuel there, the problem is at the needle valve or float; if no fuel. the problem liies between the carb and the tank, next methodical check would be the fuel filter, etc.

User Avatar

Trouble code P1538 means: Intake Manifold Runner Control Stuck Open (Bank 2)

User Avatar

use an oil filter remover, i find the strap type that uses a ratchet works best, the chain type distroys the filter and you get oil everywhere

User Avatar

The old oil filter gasket might still be stuck on the engine block. Having the two gaskets in place will not allow the filter to seat correctly causing a leak.

User Avatar

your rear windshield motor may be stuck on. try freeing it by hand.

User Avatar

Just give them a warning and get a new pair of scissors. We all do stupid stuff.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.