It is located over your head in the panel that controls the garage, sun roof, etc. Use something flat such as a butter knife and pry on the side closest to the back of the car. Once that is down, there are 3 cables that you will disconnect. THEN you will need a 8mm socket to unscrew 4 bolts. (i used pliers) Once the 4 screws have been removed, the inner case will pop free. In that case is another cable. This is the cable that plugs directly into the HFL. Simply pull it out.
Disconnect the battery for 5 min
Disconnect the Battery for 5 minutes
disconnect the ac compressor and reconnect it
Disconnect the negative terminal to the battery for 3 min.. It worked for me :)
The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.
The 3.0 Acura CL alarm system is wired into a car alarm brain. This will need to be disconnected. It is advised that a professional disconnects it as doing this incorrectly will leave the car unable to be used.
To replace the rear corner lights on a 1998 Acura CL open the trunk. Find the brake light housing and disconnect the bulb. Install the new bulb.
Lift the Acura. Drain the power steering fluid. Disconnect the steering joints from the power steering rack. Unbolt the race and remove. Install the new rack and connect the steering back up.
The driver side electric window switch on a 1992 Acura Integra is reached by removing the door panel. Unbolt the switch from the mounting bracket and disconnect the wiring from the harness. Replace the unit.
The intake manifold on a 1990 Acura Integra connects to the head of the engine. Loosen all of the nuts from the manifold to the head, disconnect the throttle body, vacuum lines, fuel injectors and coolant lines then pull the manifold from the head.
Disconnect fluid linesRemove mounting boltsSlide cylinder out of booster REMEMBER TO BENCH BLEED NEW MASTER CYLINDER PRIOR TO INSTALLATION
It is located under the steering wheel. Grey Box with a Blue socket. Disconnect it and push it up and the grey box comes right out. I hope that helps