This is easy, you need to remove the small bolts that hold on the U joint to the drive line. Be careful removing the driveline from the yolk of the transmission because there are small roller bearings inside the caps of the U joint that may fall out.
On a 1993 Ford Aerostar : The automatic transmission modulator is on the passenger side of the transmission ( it might be behind a heat shield )
According to the 1997 Ford Aerostar Owner Guide : ( Motorcraft MERCON automatic transmission fluid is used as the power steering fluid )
For a manual transmission: 5.6 pints. For an automatic transmission: 19 pints.
Yes, automatic transmission fluid is the proper fluid for power steering systems. ----------------------------------------------------------------------------------------------------- ( MERCON ) automatic transmission fluid in a 1997 Ford Aerostar power steering
The automatic transmission uses 19 pints or 9.5 quarts.
No!
A 1994 Ford Aerostar manual transmission will hold 1.2 liters of API GL-5 SAE 80W90 transmission oil. An automatic will hold 10 quarts if the lines are completely flushed.
Unless it has a sealed for life transmission, you put fluid down the dipstick, where you check the fluid level.
i dought it, these vans are extremely specific when it comesto their parts, i can't evn find the right power steering pump for my van
Its my understanding that the 92 and 93 Tranny is the same for the two years. It might make a difference if one is a electronic 4-wheel drive and the other is not.
On the Ford A4LD automatic transmission the modulator valve is on the passenger side of the transmission ( it might be behind a heat shield )
( No ) the 1997 Ford Explorer uses automatic transmissions that are ELECTRONICALLY controlled , where the 1992 model year is not ( P.S. I'm not a mechanic / technician )