0
I also have an 88 Burban 350 TBI, but you basically need to strip the engine down to the heads and either have them machined with new valves, guides, rockers (if needed). To do this you need to find a good machine shop and have it done. You cant do it yourself without expensive equipment. It all depends you might be able to get new heads or even a "long block" for the price some times.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What is the cost for a valve job on a 1999 GMC suburban?
A valve job for your 1999 GMC Suburban will cost approximately $800. The parts will cost around $200 and require 10 hours of labor.
1988 Yamaha 350 warrior has a smoking issue?
Probibly needs a valve job.
How do you do a valve job on a 1996 suburban?
i can tell you how to do it, if you have a good knowledge of engines it's not hard but is time consuming. you can call me at 636-575-0255, thanks harry
1997 suburban wont down shift when accerating?
I have a 1999 GMC Suburban with the same problem but it did not show up until I had removed all of the wiring harness from the engine for a cylinder head job. I am going to look at the throttle position sensor and wiring connector tonight.
Do you need to pull the engine 3.0 6 of a 1994 LeBaron to do a valve job?
No, you do not have to remove the engine to do a valve job.
How do you do a valve job on a 1988 suburban?
I also have an 88 Burban 350 TBI, but you basically need to strip the engine down to the heads and either have them machined with new valves, guides, rockers (if needed). To do this you need to find a good machine shop and have it done. You cant do it yourself without expensive equipment. It all depends you might be able to get new heads or even a "long block" for the price some times.
What is the sequence for a valve replacemnt on a 1988 Chevy Celebrity?
It sounds like you are asking how to do a valve job on your 1988 Chevy Celebrity. There is much more to doing a valve job than there is space to write it all out here The answer to that question can best be found in a manual such as the factory service manual, a Chilton manual or a Haynes manual. There you will find illustrations and instructions on the various steps involved in tearing down and reassembling an engine. It will also give specific instructions as to how to readjust the valves, torque values as well as the sequence to follow to tighten head bolts correctly.
How do you seal an intake valve on a 1996 Chevy blazer?
Do a valve job. This is more complicated than it sounds, you might be better off sending the head to your local machine shop for the valve job.
PCV valve on a 95 Honda Civic?
Pcv valve job on 95 civic
Where would I look into getting a job at GMC automotive?
When you are trying to get a job with GMC automotive you might want to call the local GMC to see what they have for openings. Some jobs are just changing oil while others are more in depth. Many of the GMC automotive place will help you get ASE certified but they will help in that area as well.
What size torx 2004 gmc sierra brake job?
55
What is a three angle valve job?
The area where a valve closes in the combustion chamber of a four-stroke engine is called the valve seat. During a valve job, this seat is ground at a set angle, usually 45 degrees, for a good seal. In a three-angle valve job, additional angles are ground into each side of the seat angle to ease the transition and improve flow.
