answersLogoWhite

0


Best Answer

u can try & pump the fluid out of the fill hole. or take out the rear end bolts, pry cover loose drain fluid put on new qasquet re tighten & fill with fluid

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you drain gear lube in a 1978 corvette rearend?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What gear ratio is a nissan HF37 rearend?

3.73


What type of rearend gear oil for 97 Chevy Suburban?

85W90 gear oil.


Can you use a different gear ratio for rearend?

yes, but not if 4wd


Can you find rearend gear ratios using your VIN number?

1gnek13t63j210068


What is the gear ratio for Chevy Monte Carlo 1985?

more than likely it's a 3.08 gear in the rearend.


What kind of grease goes in 1991 Chevy pickup rearend?

80 or 85W90 gear oil.


How many miles does a 1969 dodge charger get to a gallon?

that all depended on the engine in it and the rearend gear.


How do you tell what size rearend you how on a 1999 Chevy blzer4x4?

Open the cover, count the teeth on the big gear ( the ring gear ) next count the teeth on the small gear ( the pinion gear). Divide the big gear by the little gear and that is your ratio.


What other cars have same rearend as 93 jeep wrangler 3.07 gear ratio?

Jeep Wrangler only,


Is there a way to find out what size rear end is in a 6cyl 1968 nova?

Do you mean gear ratio or rearend size?


How do you replace the rearend gears on a Polaris 325 4x4 the rear drive shaft turns but wont engauge?

To replace the rearend gear on the Polaris 325 You have to jack it up and remove the eight bolts that holds the rear end cover on. After you remove it you simply have to pull the old gear out and install the new one.


How do you remove an axle bearing on a 2003 ford crown Victoria?

If you are talking about the rear axle bearing you have to open cover on rearend ( differential) You`ll see a small bolt on pinion gear shaft. Remove it. You mave have to put vehicle in nuetral to turn rearend gears to slide pinion gear shaft out of the way.There are 2 c-clip like things that slide out. This will allow axle`s to slide out of rearend. Now you have to go to auto-zone or wherever and rent a bearing puller to remove bearing from rearend.