Use the link below to find your model (or one close to what you have), and then download the user manual. Contact information for Talon can be found on their home page, which you can access from the page for which the link is provided.
Drain the oil out of the same hole you fill it through. Run the mower to heat the oil, remove filler cap, invert mower over suitable container, make sure it's completely empty, and then refill with the appropriate oil to the correct level.
drain it.
Many Yardman Lawnmower models do not have a drain plug. If no drain plug is found the oil has to be removed by the oil fill tube.
If the wrong oil is used in a lawnmower, do not start it. Simply drain the oil as completely as possible and fill with the proper oil.
Depending on the model of the Craftsman lawnmower, there is either an oil plug underneath the deck of the mower which needs removed to drain the oil or the lawnmower needs tipped on it's side to allow the oil to drain out through the oil cap area. Once oil has drained you will want to refill the oil until the dipstick registers "full".
There is none you suck the oil out with a pump provided by the dealer.
All you can do is drain the oil out of the lawnmower and replace it with the correct oil.
Drain the oil and gas out of the crankcase and put oil back it should be OK
A bit of teflon tape can work wonders.
If its a push lawn mower. It has no oil release. The mower burns the oil. All you do is replace the oil when it gets low.
The engine floods and you have to wait for the lawnmower to drain before you start it up again or it might start smoking.
Drain the oil and catch it in a clean container if you intend on reusing the same oil . Then replace the plug and place the correct amount of oil in the motor.
With the engine off and the plug wire off the spark plug, you will need to remove the drain plug on the bottom of the engine. Drain the oil, install the plug and fill with 30w oil.