answersLogoWhite

0


Best Answer

A bit of teflon tape can work wonders.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What can be used to seal the oil drain plug in a lawnmower?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What happens if you use the wrong oil in your lawnmower?

If the wrong oil is used in a lawnmower, do not start it. Simply drain the oil as completely as possible and fill with the proper oil.


How does 94 drain plug work?

A drain plug is just a bolt used to plug a hole preventing liquid flow from that hole.


Where is the transmission drain plug on a 2002 ranger?

Automatic transmissions used on Fords do not have a drain plug in the transmission pan


What is a drain plug gasket?

A drain plug gasket is a washer type device made of plastic or other non porous material and is used between the drain plug and the oil pan to prevent leakage when the drain plug does not fit snugly in the oil pan


Can the freeze plug be re-used?

Do not attempt to reuse a freeze plug. They are pressed in to make a tight seal and will not seal properly if reused.


What size wrench is used to remove oil drain plug on 2000 Chrysler LHS?

The factory plug used a 13mmThe factory plug used a 13mm


Where would you find the plug for gas tank on 1996 Chevy Silverado?

Sorry, But there is no drain plug in any gas tanks. Ford Chevy dodge no 1 used a drain plug.


How can you remove a frozen oil drain plug in a car?

An impact wrench can be used to remove a frozen oil drain plug in a car. If the drain plug is frozen due to the weather, the best thing to do is to put the car in a heated garage for a few hours.


What is a radiator petcock?

Radiator drain plug. Located at the bottom or lower side of the radiator used to drain coolant from the radiator.


How do you change the oil on a 2003 Honda Civic?

buy new oil filter, oil, and a new drain plug and gasket. the used plug is prone to leakage. remove drain plug and drain in a big enough pan for all the oil. oil filter is located on rear of engine. easier to remove from the bottom of the car. put oil on the seal of the new filter and hand tighten. replace oil plug with new gasket and plug and tighten to 33 foot pound. add oil that is required and start car. when oil light goes out shut car off and check oil add oil as needed.


What size wrench is used on the oil drain plug on 2007 Chevy hhr?

15mm


What is an oversized drain plug used for?

sometimes they have a magnet to catch metal shavings and particles