can you tell me were I can find my starter on my 1997 Grand AM GT
You can find the starter at the lower front part of the engine. You can change starter easily any time it has a fault.
a starter on a grand prix is behind the engine which mean you must go under and find it. once under it will be very notice able.
where is the starter locate on 1997 grand am
follow the positive battery wire. you will find a boxy looking this about 8 inches long... this is your starter
Where is the starter on a 1998 Pontiac Grand Am, 6 cylinder
Defective starter solenoid?
on the lower half of engine,on side of oil pan closest to the front of car. Usually has a couple bolts holding it on.
It's attached to the starter.
On the starter
how to replace starter on 2000 mercury grand marquis
The crankshaft sensor is behind the Starter. You have to remove the starter to get to it. You may be able to see it from underneath the car. I had to replace one today..It's a pain in the neck but my car is running great..
Should be mounted at the top of the starter
How do you replace starter on2.3 cy 1991 pontiac grand am
It is on the starter.
what does the grand am have in it now
The solenoid is attached to the starter. There is no relay.
91 le grand - 2005 was released on: USA: 2005
on the starter. Chevy has always put the starter solenoid on the starter. It is the cylinder on top of the starter that is about two inches inb diameter with all the wirs connected to it.
follow the positive battery wire.... you will find a box about the size of a 24 ounce can of pop (the bigger ones) this is your starter
Follow your red or positive cable from the battery down. It is connected to the starter.
The Starter solenoid is located on the starter itself.
Begin by removing the positive cable from your 1991 Pontiac Grand Am battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
The 1995 Pontiac Grand Am starter relay switch can be found on the firewall in the engine compartment. The starter relay switch will be on the drivers side of the firewall.