In order to access it you have to remove the upper radiator hose from the engine.The alternator might have to be loosened a bit for proper work space.Make sure the new one is put in the same position as the old one.A bit of trial and error might be needed but,thats the general area of the thermostat.
under the housing that the upper radiator hose connects to
The automatics are not interchangeable.
There are two temperature sensors in a 1995 5.2 Dodge. There is one on each side of the thermostat housing on the front of the engine.
Where is the EGR valve located on a 1995 dodge 1500 5.2 liter
where is the thermostat located on a 1995 dodge stratus? 2.4l 24 valve. v6 engine
Same engine? If so then yes.
Step by step detailed instructions but no videos are available......
1994 and 1995 only.
Remove the wiring harness from the back of your 1995 Dodge Ram horn. Remove the horn retaining bolts. Reverse the process to install the new horn.
The 1995 wheels will not clear the brakes if you put them on the front of a 2002.
If the 2002 is a 1500, no.
How do you replace a slave cylinder on a 1995 dodge neon clutch
I don't believe that the rim will fit over the front hub on the 1995.
Your thermostat is possibly not opening up. Replace and flush and then recheck. Good luck.
The hose that goes in the top of the engine, the thermostat is in the hose.Unscrew the hose take the thermostat out and replace,Very easy
No safety/inertia/reset switch on a Dodge.
The 1995 Dodge Ram 1500 uses an OBD 1. You can double check this bu looking at the emissions sticker under the hood.
They will fit on the 1995 if it is 4wd, the rim will not clear the front hub on a 2wd.
No, 1995 was OBD I. The diagnostc connecter is under the hood.
The 1995 5.9L had EGR, the 2002 did not.