Any auto junkyard should be able to help you.
replace the whole steering wheel cause once the buttons have melted??...they wont work anyway.
the air bag needs to be removed in order to have access to the screws holding down the switch.
You have to replace the whole button.
Have to replace the whole switch
The switch is on the steering column about 18 inches from the floor. Simply take 2 screws holding it on and replace it.The locck cylinder is under the steering wheel.
Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
Most steering wheel buttons bulbs are not serviceable, you must replace the button(switch) or the shole horn pad, most dash and switch bulbs are not serviceable
why would you do that?
They are pressed in and out with a set of special tools.
Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?
If you mean the CONTROLS on the steering column (audio and cruise control buttons) are not working, there is a module buried deep within the steering column that allows the wiring from these controls (as well as the airbag) to maintain their connections to the vehicle circuitry even while the steering wheel is turning. It is called a "clockspring", and it's a bear to replace. Runs $350-500 at the dealer. This problem is very common to the LS.
cost to replace heater core 1994 corsica