To answer this question call a furnace person and ask him your question okay because nobody knows this. Stupid people!
P.S. Why do you want to know this anyway?
The rate of flow of electric charge isamperage."Amperage" is slang. The correct term is current.
suitable winding and correct power supply
The correct answer is Electric motor. An electric motor is a device used to convert electricity into mechanical energy whereas an electric generator converts mechanical energy into electrical energy.
Probably the fact that a typical electric current is made up of moving electrons. Also, the fact that it carries energy.
Installing a wall scone with an electric light can be an easy process. First the power must be turned off to prevent electric shock. Then a hole should be cut to fit the fixture and expose the wires. Match up the correct wires to the light then place the sconce in the wall. Secure the sconce with glue or nails and test the light connections.
Tt depends on the metal which is the cathode and which is the anode. However, in most cases, graphite is the cathode and the metal is the anode. the strictly correct answer is that BOTH the metal and the graphite rod are electrodes. You must have two electrodes minimum to create a cell.
what is the correct sequence in the policy making process
The correct sequence of the levels of biological organization are organism, population, community, ecosystem, and biosphere.
The list of choices that you posted along with your question does not include any correct sequence.
The correct complimentary DNA sequence would be AGTCCTGGC. The correct complimentary mRNA sequence would be AGUCCUGGC.
The color sequence of a rainbow is red orange yellow green blue.
acestoonnnid
"CCM" is not a correct sequence.
vague.
Per the choices given, the correct sequence in phagocytosis would be: chemotaxis, adherence, ingestion, digestion, killing
They shouldn't. When using the correct electrode and amperage they will get hot but not red hot. Uncoated electrodes do get red hot but are not used in most applications. Too much amperage is usually the problem.
Refer to the factory manual for correct sequence. Loosening sequence if different to tightening, and both should be done in steps, not all at once. Lightly oil thread and under head of bolts and torque as instructed in the manual. Use a new head gasket and clean the head and block surfaces. Take care not to scratch or damage the sealing surfaces. Use a torque wrench and the proper 10mm 12 point deep socket.