Acura Integra

How do you find the engine fan sensor switch on an 1989 Acura Integra LS?

353637

Top Answer
User Avatar
Wiki User
Answered
2006-05-21 13:54:09
2006-05-21 13:54:09

UNDER HOOD, DRIVER SIDE, FRONT ENGINE AREA, MOUNTED ON BOTTOM OF RADIATOR

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


91 acura integra has a b18 91 acura integra has a b18


The fan switch on a 1995 Acura Integra is located on the dashboard. It is a part of the temperature control system.


The 1991 Acura Integra fuel cutoff switch can be found in the fuse box. The fuse box is in the engine compartment. The cutoff switch location can be found on the inside cover of the fuse box.


The speed sensor on a 1989 Acura Integra is located on the transmission. It is a small unit with a two-wire clip which connects to the main engine harness of the vehicle.


location of fuel relay on 1987 acura integra


You can fit a 1.8 liter engine into your 1987 Acura Integra. You will need to modify the engine mounts and the wiring harness.


Acura Integra had a B18A1 engine.


left rear top of the engine on the intake manifold mounted and held in by screws


it is located on the firewall side of the engine to the left of the oil filter


The IAT sensor, or intake air temperature sensor, is located on the tubing the of intake on a 1991 Acura Integra. This sensor reports the temperature of air coming into the engine directly to the ECU.


The 1997 Acura Integra fan relay switch is located inside of the fuse box. The fan relay switch will be in the third column, second from the top.


The fuel filter on a Acura Integra is located near the rear of the engine. More specifically it is mounted on the firewall of the engine bay.


The 1992 Acura Integra master window switch is interchangeable with other 1992 models. The master window switch was used in all 1991 through 1994 models.


The water pump on a 94 Acura Integra is located on the front of the engine. It uses the power of the engine to circulate hot water from the engine to the radiator to cool it.


The ecu code 17 in the 1988 acura integra is for the VSS (vehicle speed sensor). Hope this helps you.


The cooling fan is activated by a sensor, and possibly a relay. Most likely the sensor has gone bad.


Answermy 99 acura integra has a fuse for gauge cluster, alternator, speed sensor vss o2 sensor is fuse 15 under the dashboard that fuse control all of them check that out


Acura Integra Gsr B18C1 Vtec


inside the distributor inside the distributor


The driver side electric window switch on a 1992 Acura Integra is reached by removing the door panel. Unbolt the switch from the mounting bracket and disconnect the wiring from the harness. Replace the unit.


There is 2 o2 sensors on 96 integra. 1 is after the headder and the 2nd one is at the end of the cat


it is under the transmission. u can see part of the wire when you are looking into the engine bay. the wire should be close to the radiator.


there really isnt. a 90-93 integra has the b18a1 engine and the 94-95 integras have the b18b1 engine. the only difference is some small wiring differences and sensors that were added to the 94-95 integras


You can find your 1988 Acura Integra starter on the right hand side of the engine. You can follow the positive battery cable directly to the starter.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.