Best Answer

There isn't a "cable" like there used to be. The speedometer/odometer is controlled by an eletroic speed sensor. A wiring harness plugs into the back of the dash module containing the speedo.

User Avatar

Wiki User

โˆ™ 2015-07-15 21:37:07
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you find the odometer cable coming through the firewall and connecting to the meter itself in the dash of a 1996 Honda Accord EX?
Write your answer...

Related Questions

Is there a fuse for the odometer at Honda Accord 1997?

is there afuse for the odometer at Honda accord 1997

How to disconnect accord odometer?

It is illegal to disconnect an odometer. Why would you want to do this?

What is an easy way to go through firewall on 2002 Honda Accord?

a drill, be careful ... ;)

Where is the location of a canister of Honda Accord?

1980 accord its against the firewall on the passenger side.

Is there a way to run a amp wire through the firewall on a 1998 automatics Honda accord?

Most people would drill a hole.

How do you repair the odometer of a 2001 Honda Accord?

If the speedo works and the odometer doesn't, it neeeds to go to the speedo shop as the problem is inside the spedo. GoodluckJoe

Where is the odometer located in 2006 Honda Accord?

Under the speedometer. Push the trip meter reset button and the display will change from outside temperature to the odometer.

Where is the blower motor resistor on a 91 accord?

The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.

Where is the odometer button on a Honda accord 2003?

On the dash, right below the temperature gauge.

Where is the blower motor relay on a 89 Honda Accord?

The 1989 Honda Accord blower motor relay switch can be found on the firewall in the engine compartment. The blower motor relay switch will be on the passenger side of the firewall.

Why would the odometer on a 1994 Honda Accord fail intermittently and how do you fix it?

If the odometer also quits, the problem is probably the speed sensor or wiring to it. If the odometer keeps turning when the spedo quits, it is in the spedo itself and needs to go to the speedo shop.

What can be done to fix the odometer in a 1994 Honda Accord?

TAke it to a speedo shop as something is wrong in the speedo itself.

Where is water pump bypass hose located for 1994 Honda Accord?

on the firewall, there are 2

Do you have a picture of fuel filter on a 1993 Honda Accord?

Clink the link. Located on the firewall.

Where is the heater control valve on a 1996 Honda Accord located?

Passenger side firewall

You have a 1999 accord lx v4 83k miles you noticed this morning that the backlight on the odometer module was not working the odometer works but no illumination help?

1999 lx "V4"?you moron, buy a service manual.

What could cause the speedometer odometer temperature and fuel panel gauges not to work on a 90 accord LX?

have you checked your fuses?

Where is the firewall located on a 1991 Honda Accord?

It is the panel between the engine compartment and the passenger's compartment.

Where do you find the fuel filter on a 1992 accord lx?

Check along the firewall in the engine compartment

What does a map sensor on a 1992 Honda accord ex look like?

Depending on your Accord, it's located either on the top of the throttle body or on the firewall. If it's located on the firewall, look for a vacuum hose going to the throttle body. Click the link for a photo.

Where is the diagnostic connector on a 2001 Honda Accord?

The diagnostic connector on a 2001 Honda Accord can be found in the engine compartment. The connector is located on the passenger-side in front of the firewall.

Where is the main fuse on the 2000 Accord?

The main fuse for a 2000 Honda Accord is located in the main fuse box in the engine compartment. It is in a water tight box, near the firewall.

What is the easiest way to run wires through a 2001 Honda accord firewall?

Drill a hole under the dash board on the passenger side then once all wires are going through it use Ultra black sealant so no water get ins

Why are your two inner cylinders connecting in your 1990 Honda Accord and the compression goes to the radiator?

You have a blown head gasket.

What are the torque specs on a 1994 Honda Accord connecting rod?

34 ft-lbs according to haynes manual.