0
Add your answer:
Earn +20 pts
How do you get to heater blower resistor on 91 Chrysler 5th?
usually by the blower motor -- look behind glove box area or under hood near blower motor
Where is the relay for a 91 Honda accord blower motor located?
behind the glovebox.gm Jim
Where is the heater blower motor resistor located 91 chevy truck and how do you remove it?
Its should be behind the glove box.. held in by 1 screw
Where is the AC-heat blower motor resistor on a 91 Chrysler 5th Avenue?
I know it in the dashboard. I think all Chrysler have it in the dashboard now
Why would the blower fan stop blowing air from the vents if the fan speed is not set on high on a 91 town car?
Low speed relay bad Blower fan resistor Defective winding in blower motor
Where to check motor oil on a 91 Honda Accord?
Via the dipstick
Where is the blower motor resistor on a 91 Toyota pickup?
It is bolted to the firewall just under the glove box. So on passenger side below the glove box, all you will see is the wires going into a plastic piece with two screws holding it in, remove wire connector, unscrew screws, and pull resistor out, be careful not to damage more, as the resistor for this year is exposed. it is actually mounted in the air duct to keep it cool you will see it behind (and up) the blower motor
Where is the blower motor on a 91 caprice located?
lower right dash, underneath the glovebox
Where is the blower motor on a 91 Chevy C1500 pickup?
under the dash on the passenger side.
Where is the location of the heater blower resistor for a 91 grand prix?
passenger side floorboad behind the relay panel in the dash
Why is 2001 dodge Dakota blower motor not working and has 12 volts both sides of the motor connector?
I am not sure if this is the correct answer or not. But in my 91 Dodge Dakota I thought it was the blower motor so I replaced it and it still did not work. What I had to do was look under the hood for the resistor. On my truck, it was mounted threw the firewall by 2 screws on the passenger side near the top of the firewall and had wires pluged into it. Remove the screws and pull out the resistor and see how it looks. If one of the wires are broken you can simply repair this by bending the broken wire and inserting it into the slot beside where it had prevously been and recrimp the wire inplace. Then put the resistor back into the firewall and you should now have your blower motor working again.
How do you fix No low and medium blower speed when high speed blower works fine on a 1987 Corvette?
More than likely the blower resistor is bad....I recently ran into this problem in my 91 Vette...Hope this helps!
