Want this question answered?
You will have to replace the complete window regulator assembly.
yes the is a single assembly. replacement assembly is available here http://www.doctorautoparts.com
Because your switch is bad, replace the light assembly
Forget it. I figured it out.
why does my heating not work in peugeot partner van year 2000?
Not possible. You have to remove the whole light assembly.
Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.
on top of headlight assembly are 2 plastic slide pins, pull up on these to release assembly. when putting back on. push in on assembly to put slide pins down to hold assembly in.
To replace the tail light bulbs in a 2000 Dakota open the tail gate. You will find two screws on each side that hold the tail light assembly in place. Unscrew these two screws then pull the assembly straight back. There are two pins holding the assembly so do not pull to the side they must come straight back.
drill a small hole in the back or bottom of the head light assembly to allow the moisture to escape.
The Tail light assembly is mounted by two Philips head screws located near the boot rubber, take them out and slide the tail light assembly away from the center of the car. Then Bob's your Auntie.
Open trunk, remove the 2 screws outside the light assembly (right side of light assembly for back light driver side & left side of light assembly on passenger side). Once you remove these 2 screws there are 2 more screws inside the light assembly. To remove the light assembly to access the break light & other bulbs you must work the 2 remaining screws out of the 2 slotted plastic pieces that holds these 2 screws. So you may have to work the assembly left to right & right to left to free up the assembly. Once you replace the bulb line up the 2 screws to the 2 slotted plastic pieces, push light assembly in & screw in the 2 outer screws.